Understanding the Printer Menus 273
Va lu es :
Adobe Protocol
Purpose:
To specify PostScript communication protocol for a parallel interface. You can configure the Adobe Protocol settings
for the wired network. The change becomes effective after the printer is turned off and then on again.
Va lu es :
Default Settings
Use Default Settings to modify the Copy, Scan Menu, or Fax menu defaults.
Copy Defaults
Purpose:
To modify the Copy menu defaults.
Copy Defaults allows you to configure the following items in addition to the items under the Copy menu.
Auto Exposure Level
Purpose:
To specify the default background suppression level.
Va lu es :
Color Balance
Purpose:
To specify the default color balance level within the range of -3 to +3.
Va lu es :
Disable Disables the USB interface.
Enable
*
Enables the USB interface.
Auto Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP* Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Binary Used when no special processing is required for data.
Normal
*
Sets the background suppression level to Normal.
High Sets the background suppression level to High.
Highest Sets the background suppression level to Highest.
Yellow Low Density 0
*
Sets the color balance level of low density yellow.
Available Range: -3 to +3
Med. Density 0
*
Sets the color balance level of medium density yellow.
Available Range: -3 to +3
To Next Page
Loading...
Need help?
General
