4. Follow the procedures in After Working Inside Your Computer.
Removing the Coin-Cell Battery
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a) computer cover
b) optical drive
c) memory shroud
3. Press the release latch away from the battery to allow the battery to pop-up from the socket. Lift the coin-cell battery out of the
computer.
Installing the Coin-Cell Battery
1. Place the coin-cell battery into the slot on the system board.
2. Press the coin-cell battery downward until the release latch springs back into place and secures it.
3. Install:
a) memory shroud
b) optical drive
c) computer cover
4. Follow the procedures in After Working Inside Your Computer.
Removing the PCI Card
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the computer cover.
3. Open the plastic latch fastening the PCI card in its slot.
4. Press down the latch and pull the PCI card away from the computer.
Removing and installing components
23
To Next Page
Loading...