Setting up the monitor │ 15
Setting up the monitor
Attaching the stand
NOTE: The stand is not installed at the factory when shipped.
NOTE: To prevent scratches on the LCD screen when removing the
stand, ensure that the monitor is placed on a soft, clean surface.
NOTE: The following instructions are applicable only for attaching the
stand that was shipped with your monitor. If you are attaching a stand
that you purchased from any other source, follow the set up
instructions that were included with the stand.
1. F
ollow the instructions on the flaps of carton to remove the stand from the
top cushion that secures it.
2. Inse
rt the stand column into stand base until it clicks into place.
3. Place the monitor on a soft cloth or cushion near the edge of desk, and then
insert the stand assembly to the monitor.
To Next Page