Installing the 2230 solid-state drive/Intel Optane memory
module
Prerequisites
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the solid-state drive/Intel Optane memory and provides a visual representation of the
installation procedure.
Steps
1. Locate the notch on the 2230 solid-state drive/Intel Optane memory.
2. Align the notch on the 2230 solid-state drive/Intel Optane memory with the tab on the M.2 card slot.
3. Slide the 2230 solid-state drive/Intel Optane memory into the M.2 card slot on the system board.
4. Replace the screw (M2x3) that secures the 2230 solid-state drive/Intel Optane memory to the system board.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
NOTE:
Enable the Intel Optane memory after you replace the Intel Optane memory module. For more information about
enabling the Intel Optane memory, see Enabling Intel Optane memory.
34 Disassembly and reassembly
To Next Page
Loading...
