Steps
1. Insert the power button switch into the slot from the front-side of the computer, and press until it clicks into the place.
2. Align and connect the power button cable to the system board.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
The following images indicate the location of the intrusion switch and provides a visual representation of the removal procedure.
56
Disassembly and reassembly
To Next Page
Loading...
