Install rail brackets using the adapter hardware (for threaded hole racks)
l
If you are using a rack with square or round holes, go to Install rail brackets on the
Data Domain racks (for square or round hole racks) on page 40 section.
l
Only use this procedure if your rack has tapped holes that are M5, M6, 10/32, or
12/24.
l
The adapter hardware is shipped in the rack mount kit.
l
You will need a long handled screwdriver with a shank diameter less than 7.0 mm
and the wrench (included in the kit) to tighten the nuts.
Procedure
1. Locate the two adapters from the rail kit.
Figure 25 Adapters
1. Long adapter
2. Short adapter
2. Attach the long adapter to the front of each rail using M5 screws.
Install the System in the Rack
Install rail brackets using the adapter hardware (for threaded hole racks) 43
To Next Page
Loading...
