90 Removing and Installing Parts
7
Check all cables to be certain that they are properly connected and firmly seated.
8
Replace the computer cover (see "Replacing the Computer Cover" on page 105).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
9
Connect your computer and devices to electrical outlets, and then turn them on.
10
See the documentation that came with the drive for instructions on installing any software required for
drive operation.
11
Check the System Setup for drive configuration changes (see "Entering System Setup" on page 111).
1 serial ATA data cable 2 power cable
1
2
book.book Page 90 Monday, July 23, 2007 3:47 PM
To Next Page
Loading...
