Dell DR4300 - Page 109

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion card riser.
Steps
Press the tabs on the riser 1 blank and push the riser 1 blank out of the chassis.
Figure 37. Removing the riser 1 blank
1. slot on the chassis 2. tab (2)
3. riser 1 blank
Next steps
1. Install the expansion card risers.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing expansion card risers
Installing expansion card risers
After working inside your system
109