Dell DR4300 - Locating Service Tag of Your System; Documentation Matrix

Table 9. Quick Sync indicator codes
Quick Sync
indicator pattern
Condition
Slow blink Quick Sync is waiting to be configured from iDRAC.
Solid Quick Sync is ready to transfer.
Blinks three times
rapidly and then
turns off
Quick Sync feature is disabled from iDRAC.
Blinks continuously
when the mobile
device touches
antenna
Indicates data transfer activity.
Blinks rapidly
continuously when
the activation button
is pressed
Quick Sync hardware is not responding properly.
Turns off Indicates that the Quick Sync feature is turned off. Use the activation button to
activate it. If pressing the activation button does not turn on the LEDs, it indicates
that power is not delivered to the Quick Sync bezel.
GUID-86B603BB-113C-45E2-B765-11AA1C626BE2
Locating Service Tag of your system
Your system is identified by a unique Express Service Code and Service Tag number. The Express Service
Code and Service Tag are found on the front of the system by pulling out the information tag.
Alternatively, the information may be on a sticker on the chassis of the system. This information is used
by Dell to route support calls to the appropriate personnel.
GUID-FFD1DBDF-FE27-4F74-B422-AC3614907ADC
Documentation matrix
The documentation matrix describes documents for setting up and managing your system.
Table 10. Documentation matrix
To... Refer to...
Install your system into a rack Rack documentation included with your rack
solution.
Set up your system and know the system technical
specifications
Getting Started With Your System that shipped with
your system or see Dell.com/support/home
Set up your Dell DR Series system Setting up your Dell DR4300 system that shipped
with your system or see Dell.com/support/home
Troubleshoot the system and install or replace
system components
Dell DR4300 System Owner’s Manual at Dell.com/
support/home
18