Dell DR4300 - Sample Memory Configurations; Removing Memory Modules

GUID-DC8F9FFB-7A9C-43AE-B25C-B2079FC6A490
Sample memory configurations
The following table shows sample memory configurations for two processor configuration that follows
the appropriate memory guidelines.
NOTE: 1R and 2R in the following table indicates single and dual ranks DIMMs respectively.
Table 32. Sample Memory configurations
System
capacity
(in GB)
DIMM
size (in
GB)
Number
of DIMMs
DIMM rank, organization, and
frequency
DIMM slot population
64 4 16
1R, x8, 2400 MT/s
1R, x8, 2133 MT/s
A1, A2, A3, A4, A5, A6, A7, A8, B1,
B2, B3, B4, B5, B6, B7, B8
8 8
1R, x8, 2400 MT/s
1R, x8, 2133 MT/s
A1, A2, A3, A4, B1, B2, B3, B4
GUID-8959921E-87A0-427A-A8EC-BE39ACF26BC3
Removing memory modules
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
4. If installed, remove the cooling fan assembly. For more information, see the Removing the cooling
fan assembly section.
WARNING: The memory modules are hot to touch for some time after the system has been
powered down. Allow the memory modules to cool before handling them. Handle the memory
modules by the card edges and avoid touching the components or metallic contacts on the
memory module.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any
memory socket that is not occupied. Remove memory module blanks only if you intend to install
memory modules in those sockets.
Steps
1. Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the
middle of the memory module or metallic contacts.
2. To release the memory module from the socket, simultaneously press the ejectors on both ends of
the memory module socket.
79