Dell DR4300 - Running the Embedded System Diagnostics from the Dell Lifecycle Controller; System Diagnostic Controls

GUID-0A3EEBD3-A15A-4F44-BA52-166762DACD9C
Running the Embedded System Diagnostics from the Dell Lifecycle
Controller
1. As the system boots, press F11.
2. Select Hardware Diagnostics → Run Hardware Diagnostics.
The ePSA Pre-boot System Assessment window is displayed, listing all devices detected in the
system. The diagnostics starts executing the tests on all the detected devices.
GUID-F3B6DEB8-E427-42C3-9290-73C6716DF21B
System diagnostic controls
Menu Description
Configuration Displays the configuration and status information of all detected devices.
Results Displays the results of all tests that are run.
System health Provides the current overview of the system performance.
Event log Displays a time-stamped log of the results of all tests run on the system. This is
displayed if at least one event description is recorded.
171