Dell EMC Integrated Data Protection Appliance DP4400 - Slide the System into the Cabinet; Verifying Successful Disk Replacement from the ACM

Figure 16 Install System cover
Slide the system into the cabinet
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click
into place.
2. Push the blue slide release lock tabs forward on both rails and slide the system
into the cabinet. The slam latches will engage to secure the system in the
cabinet.
Figure 17 Slide the system into the cabinet
Verifying successful disk replacement from the ACM
After a disk is replaced, you can run the FRU command line verification from the ACM
to ensure that the replacement was successful.
Procedure
1. Log in to the ACM command line by using SSH.
Use root for the user, and use the common password for the appliance.
Remove and replace assemblies
30 Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide