Figure 29 Installing a memory module
Install the mid hard drive tray
Perform the following steps to replace the mid hard drive tray.
Procedure
1. Lift the hard drive tray handles to 90 degrees upward.
2. Hold the hard drive tray handles, and align the slots on the hard drive tray with
the guide pins on the system.
3. Lower the hard drive tray into the system.
4. Lower the hard drive tray handles to lock the hard drive tray in place.
5. Connect all the cables to the hard drive backplane.
Figure 30
Installing the mid hard drive tray
Remove and replace assemblies
42 Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide
To Next Page
Loading...
