5. Connect the NVMe card.
Install the rear hard drive cage
Procedure
1. Align the screws on the hard drive cage with the screw holes on the system.
2. Lower the hard drive cage into the system until it is firmly seated.
3. Using Phillips #2 screwdriver, tighten the screws to secure the hard drive cage
to the system.
4. Connect all the cables to the rear hard drive backplane.
Figure 47 Installing the 3.5 inch rear hard drive cage
Install the network interface card into expansion card riser 1
Before you begin
Follow all safety guidelines.
Procedure
1. Unpack the network interface card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Pull the expansion card latch.
3. If installed, remove the filler bracket.
Remove and replace assemblies
56 Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide
To Next Page
Loading...
