3. Insert the BOSS card edge connector firmly into expansion card slot 3 until the
card is fully seated.
4. Push the expansion card latch into the slot.
Figure 38 Installing the BOSS card in expansion card riser 1
Install the system cover
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the
guide slots on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise
to the locked position.
Figure 39
Install System cover
Slide the system into the cabinet
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click
into place.
Remove and replace assemblies
Install the system cover 49
To Next Page
Loading...
