Install the system cover
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the
guide slots on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise
to the locked position.
Figure 31 Install System cover
Slide the system into the cabinet
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click
into place.
2. Push the blue slide release lock tabs forward on both rails and slide the system
into the cabinet. The slam latches will engage to secure the system in the
cabinet.
Remove and replace assemblies
Install the system cover 43
To Next Page
Loading...
