Dell EMC Integrated Data Protection Appliance DP4400 - Page 4

Remove the memory module......................................................... 40
Install the memory module.............................................................40
Install the mid hard drive tray........................................................ 42
Install the system cover................................................................. 43
Slide the system into the cabinet...................................................43
Connect the I/O cables and power cords.......................................44
Verifying successful DIMM replacement from the ACM ............... 44
M2 memory remove and replace................................................................ 45
Identifying a failed M.2 from the ACM ..........................................45
Disconnect the power cords and I/O cables.................................. 45
Extend the system from the cabinet..............................................46
Remove the system cover............................................................. 46
Replace an M.2 module..................................................................47
Install the system cover.................................................................49
Slide the system into the cabinet...................................................49
Connect the I/O cables and power cords...................................... 50
Verifying successful M.2 card replacement from the ACM ........... 50
Remove and replace NIC cards................................................................... 51
Network daughter card.................................................................. 51
Network Interface Controller (NIC) ports...................................... 51
Identifying a failed NIC from the ACM ...........................................51
Disconnect the power cords and I/O cables.................................. 52
Extend the system from the cabinet..............................................52
Remove the system cover............................................................. 52
NIC indicator codes....................................................................... 53
Remove the rear hard drive cage...................................................54
Remove the network daughter card.............................................. 54
Install the network daughter card..................................................55
Install the rear hard drive cage...................................................... 56
Install the network interface card into expansion card riser 1.........56
Install the system cover................................................................. 57
Slide the system into the cabinet...................................................58
Connect the I/O cables and power cords...................................... 58
Verifying successful NIC replacement from the ACM ................... 59
Start up the IDPA....................................................................................... 59
Start up the IDPA from Dell server................................................ 59
Start up the IDPA from iDRAC.......................................................59
Document references for IDPA 61
Service video resources 63
CONTENTS
4 Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide