Dell EMC PowerEdge R240 - Removing a 2.5-Inch Drive from a 3.5-Inch Drive Adapter

Figure 24. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
2. If removed, install the front bezel.
Removing a 2.5-inch drive from a 3.5-inch drive adapter
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
2. Remove the drive from the 3.5-inch drive adapter.
Figure 25. Removing a 2.5-inch drive from a 3.5-inch drive adapter
48
PowerEdge R240 installing and removing system components