Figure 100. Removing the LOM riser card
5. Lift the LOM riser card out of the system.
6. Remove the LOM riser bracket.
a. Using a Phillips #2 screwdriver, remove the screw that secures the bracket to the chassis.
b. Slide the bracket out of the slot on the chassis.
Figure 101. Removing the LOM riser bracket
7. If the LOM riser card is not being replaced immediately, install the LOM filler bracket.
a. Insert and slide the LOM filler bracket into the slot on the chassis.
96
Installing and removing system components
To Next Page
Loading...
