Apply Performance Profiles to system components
You can use the VxFlex OS GUI to apply performance profiles to system components.
About this task
The default configures a predefined set of parameters for very high performance use
cases. When a container is provided in the command (System/Protection Domain/
Fault Set), all the objects currently in the container are configured.
Note: For a complete list of parameters controlled by the profiles, refer to "VxFlex
OS Performance Fine-Tuning ".
The profiles are applied separately to:
l
SDSs
l
SDCs
l
MDM cluster
Note: After changing the performance profile of an SDS (on an SVM), you
must perform manual memory allocation on the SVM, as described in the
VxFlex OS Deployment Guide
.
To apply a profile to system components, perform the following steps:
Procedure
1. Depending on the system component that you want to configure, in either the
Backend > Storage or Frontend > SDCs view, navigate to, and select the
desired objects.
Note:
If you want to apply the Performance Profile to MDMs, select the
System object.
2. Right-click the object and select Set Performance Profile for XXX, where
XXX represents one of the following:
l
MDMs
l
All SDSs
l
SDS
l
All SDCs
l
SDC
The Set Performance Profile for window is displayed.
3. Select a profile from the drop-down list, and click OK.
VxFlex OS performance fine-tuning
128 Dell EMC VxFlex Ready Node AMS User Guide
To Next Page
Loading...
