Name: Dell Force10 MXL Blade
Brand: Dell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

8 Hardware Overview

Then save the configuration and reload the switch.

FTOS# write memory

FTOS# reload

Figure 1-2. MXL 10/40GbE Switch: Plug-in Modules

NOTE: You can only hot-swap plug-in modules of the same type without requiring a

reboot. For example, you can replace a 2-Port 40GbE QSFP+ module only with

another 2-Port 40GbE QSFP+ module.

On the MXL 10/40GbE Switch, you can configure uplink ports of the same

speed on different modules in the same link aggregation group (LAG). You

can also use individual ports for uplink connections.

NOTE: A maximum of 16 ports are supported in a LAG.

For switch stacking, you must use a 40GbE port on the base module or on a

2-Port 40GbE QSFP+ plug-in module. Stacking is not supported on 10GbE

ports.

All FlexIO plug-in modules, transceivers, and attach cables are sold separately.

4-Port 10GbE SFP+ Module

4-Port 10GBASE-T Module (100Mb/1GbE/10GbE)

2-Port 40GbE QSFP+ Module

Other manuals for Dell Force10 MXL Blade

Questions and Answers:

Need help?

Do you have a question about the Dell Force10 MXL Blade and is the answer not in the manual?

General