26
Setting up the monitor
Connecting your monitor
WA
RNING: Before you begin any of the procedures in this section, follow the Safety instructions.
WARNING: For your safety, be sure that the grounded power outlet you plug the power cord into is accessible to the
operator and located as close to the equipment as possible.
To disconnect power from the equipment, unplug the power cable from the power outlet by grasping the plug firmly.
Never pull on the cord.
WARNING: A certified power supply cord has to be used with this equipment. The relevant national installation and/
or equipment regulations shall be considered. A certified power supply cord not lighter than ordinary polyvinyl chloride
flexible cord according to IEC 60227 (designation H05VV-F 3G 0.75 mm² or H05VVH2-F2 3G 0.75 mm²) shall be used. An
alternative flexible cord is synthetic rubber.
NOTE: Do not connect all cables to the computer simultaneously.
NOTE: Dell monitors are designed to work optimally with Dell supplied inbox cables. Dell does not guarantee the video quality and
performance when using non-Dell cables.
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect HDMI or DP cable from your monitor to the computer.
Connecting HDMI cable
Figure 15. Connecting HDMI cable
Connecting DP cable
Figure 16. Connecting DP cable
To Next Page
Loading...
