Dell HBA multipathing using iDRAC
iDRAC 9 maps paths together for the drives managed by the controller. In iDRAC, each physical drive is presented once on the
Storage Configuration page. To determine if your drive is in a multipath configuration, select Storage > Enclosures, expand
the enclosure that is in a redundant path setup, and select Advanced properties > Redundant path > Present.
Dell HBA multipathing using Linux
For information about configuring Dell HBA multipathing using Linux, see the Linux administration documentation. Use the
Multipath-l commands to display path information.
Dell HBA multipathing using VMware
ESXi by default provides the VMware Native Multipathing Plug-In (NMP), which automatically maps paths and manages drives
in a multipath configuration. For more information, refer to VMware documentation on NMP.
16 Multipath support on Dell HBA355e Adapter
To Next Page
Loading...
