Dell HBA355e - Selecting Drive for OS Install in Legacy Mode; Adapter Configuration Change Message; Incompatible Firmware Image; Additional Disks in Command Line Interface

Applies to Dell HBA355i Adapter, Dell HBA355e Adapter, and Dell HBA350i MX
Selecting drive for operating system installation in legacy mode
Description While installing an operating system in the Legacy BIOS mode, select one drive as the Legacy OProm
Boot Device and use that device as the installation target to boot successfully.
Applies to Dell HBA355i Adapter, Dell HBA355i Front, and Dell HBA350i MX
Adapter configuration change message
Description When you perform controller migration multiple times between systems, Legacy BIOS displays the
message Adapter configuration may have changed, reconfiguration is suggested.
Cause This error indicates that corresponding drives attached to the controller might not be enumerated
properly.
Solution Avoid controller migration multiple times between systems.
Applies to Dell HBA355i Adapter, Dell HBA355e Adapter, Dell HBA355i Front, and Dell HBA350i MX
Incompatible firmware image when incorrect payload is used
Description
If you have selected an incorrect firmware payload using the PERC CLI to update the controller firmware,
the controller is updated with an incompatible firmware image without any notification.
Cause Incorrect firmware payload is selected.
Solution Select the correct firmware and run the firmware update again.
Applies to Dell HBA355i Adapter, Dell HBA355e Adapter, and Dell HBA350i MX
Additional disks displayed in the command line interface
Description
If a ME484 enclosure is connected to Dell HBA355e Adapter, additional disks with 0 KB are displayed in
the physical disklist (PDlist) output of the PERC CLI commands (show and show all).
Applies to HBA355e Adapter
Intended branding information of the Dell HBA350i Adapter not
displayed
Description
The Subsystem is displayed as Dell Device 2175 instead of Dell HBA350i Adapter for Linux. In
ESXi, the controller is displayed as Fusion-MPT 12GSAS/PCIe Secure SAS38xx instead of HBA350i
Adapter. In Windows, the controller is displayed as Broadcom Fusion-MPT 12GSAS/PCIe Secure
SAS38xx instead of HBA350i Adapter
Solution This issue will be resolved in the upcoming release.
Applies to HBA350i Adapter
46 Troubleshooting