Dell Inspiron 14 7000 - 19 Removing the Display Assembly; Prerequisites; Procedure

Removing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the wireless card.
Procedure
1. Note the routing and remove the antenna cables from the routing guides on the fan.
2. Open the latch and disconnect the display cable from the system board.
3. Open the display at an angle of 90 degrees.
4. Place the computer on the edge of a table so that the palm rest and keyboard assembly is on the table and the display assembly
extends past the table edge with the display hinges facing up.
5. Remove the four screws (M2.5x5) that secure the display hinges to the palm rest and keyboard assembly.
6. Lift the display assembly off the palm rest and keyboard assembly.
19
Removing the display assembly 31