Replacing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Place the palm rest and keyboard assembly on the edge of a table with the keyboard facing down.
2. Align the screw holes on the display hinges with the screw holes on the palm rest and keyboard assembly.
3. Replace the four screws (M2.5x5) that secure the display assembly to the palm rest and keyboard assembly.
4. Close the display and turn the computer over.
5. Slide the display cable into the connector on the system board and close the latch to secure the cable.
6. Route the antenna cables through the routing guides on the fan.
Post-requisites
1. Replace the wireless card.
2. Replace the battery.
3. Replace the base cover.
20
Replacing the display assembly 33
To Next Page
Loading...
