Replacing the solid-state drive
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Topics:
• Procedure
• Post-requisites
Procedure
1. Slide the solid-state drive firmly into the solid-state drive slot at an angle and gently press the solid-state drive down until it snaps into
position.
NOTE:
Ensure that the solid-state drive is firmly seated.
2. Replace the screw (M3x3) that secures the solid-state drive to the palm rest and keyboard assembly.
NOTE:
Align the screw holes on the solid-state drive bracket to the screw holes on the solid-state drive, if
applicable.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
30
44 Replacing the solid-state drive
To Next Page
Loading...
