Insert the stands into the slots on the back cover until they snap into place on the display-assembly base.
Next steps
Follow the procedure in After working inside your computer.
Back cover
Removing the back cover
Prerequisites
1. Follow the procedure in Before working inside your computer.
CAUTION:
When servicing the computer, place it on an elevated, clean and flat surface. Place the display
flat on the surface with the stand hanging over the edge. It is recommended to remove the stand to avoid
accidental damage to the computer display when servicing.
About this task
The following image indicates the location of the back cover and provides a visual representation of the removal procedure.
Removing and installing components
15
To Next Page
Loading...
