Steps
1. Slide the media-card reader under the system board and align the screw hole on the media-card reader with the screw hole
on the display-assembly base.
NOTE: Ensure that the media-card reader cable stays above the system board.
2. Connect the media-card reader cable to the system board and close the latch to secure the cable.
3. Replace the screw (M3x3.5) that secures the media-card reader to the display-assembly base.
Next steps
1. Install the system-board shield.
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
46
Removing and installing components
To Next Page
Loading...
