Steps
1. Remove the 10 screws (M3x5) that secure the right and left display hinges to the display-assembly base.
2. Lift the display hinges off the display-assembly base.
Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
For replacement of stand or display hinges, the replacement kit is shipped with both stand and display hinges, and
you must replace both of these components together. Please refer to the procedure for removing the stand and installing
the stand.
About this task
The following image indicates the location of the display hinges and provides a visual representation of the installation
procedure.
20
Removing and installing components
To Next Page
Loading...
