Steps
1. Align the screw holes on the display hinges with the screw holes on the display-assembly base.
2. Replace the 10 screws (M3x5) that secure the display hinges to the display-assembly base.
Next steps
1. Install the I/O cover.
2. Install the back cover.
3. Install the stand.
4. Follow the procedure in After working inside your computer.
Hard drive
Removing the hard drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
About this task
The following image indicates the location of the hard drive and provides a visual representation of the removal procedure.
Removing and installing components
21
To Next Page
Loading...
