Installing the antennas
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the antennas and provides a visual representation of the installation procedure.
NOTE: Note the location of the antenna modules printed on the display-assembly base as ANT-B (black) and ANT-W
(white).
Steps
1. Align and place the antenna modules (2) into the slots on the display-assembly base.
2. Adhere the copper foil that secures the antenna cables on both sides of the display-assembly base.
3. Route the antenna cables through the routing guides on the display-assembly base.
Next steps
1. Install the power-button board.
2. Install the display hinges.
3. Install the speakers.
4. Install the system board.
5. Install the heat sink.
6. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
7. Install the wireless card.
8. Install the memory module.
9. Install the media-card reader.
10. Install the system-board shield.
11. Install the hard drive.
12. Install the I/O cover.
13. Install the back cover.
14. Install the stand.
15. Follow the procedure in After working inside your computer.
60
Removing and installing components
To Next Page
Loading...
