Steps
1. Align the screw holes on the heat sink with the screw holes on the system board and the display-assembly base.
2. In sequential order (1>2>3>4>5), tighten the five captive screws (M2x3) that secure the heat sink to the system board and
display-assembly base.
Next steps
1. Install the system-board shield.
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Media-card reader
Removing the media-card reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the media-card reader and provides a visual representation of the removal
procedure.
44
Removing and installing components
To Next Page
Loading...
