Dell Inspiron 24 5411 All-in-One - Solid-State Drive; Removing the M.2 2230 Solid-State Drive; Installing the M.2 2230 Solid-State Drive

Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
About this task
NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card
configurations on the M.2 card slot are:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive.
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
Steps
1. Remove the screw (M2x3.5) that secures the solid-state drive to the system board.
2. Slide and remove the solid-state drive from the M.2 card slot on the system board.
Installing the M.2 2230 solid-state drive
Prerequisites
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
30 Removing and installing components