Steps
1. Place the base panel in an upright position and align the screw holes on the base panel with the screw holes on the
display-assembly base.
2. Replace the 13 screws (M3x5) that secures the base panel to the display-assembly base.
Next steps
1. Install the display panel.
2. Install the antennas.
3. Install the power-button board.
4. Install the display hinges.
5. Install the microphones.
6. Install the system board.
7. Install the media-card reader.
8. Install the heat sink.
9. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
10. Install the wireless card.
11. Install the memory module.
12. Install the retractable-camera assembly.
13. Install the coin-cell battery.
14. Install the fan.
15. Install the speakers.
16. Install the system-board shield.
17. Install the hard drive.
18. Install the I/O cover.
19. Install the back cover.
20. Install the stand.
21. Follow the procedure in After working inside your computer.
68
Removing and installing components
To Next Page
Loading...
