Figure 65. Installing the middle-frame assembly
Steps
Place the middle-frame assembly on a flat and clean surface and perform the steps in the Post-requisites to install the
middle-frame assembly.
NOTE:
The middle-frame assembly consists of the following:
● Middle frame
● Base panel
● Wireless antenna
Next steps
1. Install the display panel.
2. Install the power-button board with USB.
3. Install the stand hinges.
4. Install the microphones.
5. Install the speakers.
6. Install the system board.
7. Install the integrated heat sink or, discrete heat sink, as applicable.
8. Install the M.2 2230 solid-state drive.
9. Install the wireless card.
10. Install the memory module.
11. Install the retractable-camera assembly.
12. Install the fan.
13. Install the media-card reader.
14. Install the system-board shield.
15. Install the I/O cover.
16. Install the back cover.
17. Install the stand.
18. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
93
To Next Page
Loading...
