Removing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the stand.
2 Remove the back cover.
Procedure
1 Note the antenna, microphone, and camera-cable routing and remove the cables
from the routing guides on the display bezel and middle cover.
2 Using your fingertips, press the securing clip and lift the camera assembly.
3 Disconnect the camera cable from the camera.
4 Disconnect the camera assembly from the tab on the display bezel.
53