Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Adhere the camera to the camera frame.
2 Connect the camera cable to the camera.
3 Connect the camera assembly to the tabs on the display bezel
4 Press the camera assembly into the slot on the display bezel till the securing clip
locks in place.
5 Route the antenna, microphone, and camera cables through the routing guides
on the middle cover and display bezel.
Post-requisites
1 Replace the back cover.
2 Replace the stand.
55
To Next Page
Loading...
