Replacing the control-buttons
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the buttons on the control-buttons board with the buttons on the display
bezel.
2 Slide the control-buttons board cable into the connector on the control-buttons
board and close the latch to secure the cable.
3 Slide the control-buttons board into the slot on the display bezel till the securing
clips lock in place.
4 Route the control-buttons board cable through the routing guides and adhere
the control-buttons board cable to the middle cover.
Post-requisites
1 Replace the back cover.
2 Replace the stand.
73
To Next Page
Loading...
