Table 40. System setup options—Pre-boot Behavior menu
Pre-boot Behavior
Adapter Warnings
Enable Adapter Warnings Enable or disable the warning messages during boot when the adapters with
less power capacity are detected.
By default, the option is enabled.
Warning and Errors Enable or disable the action to be done when a warning or error is encountered.
By default, the Prompt on Warnings and Errors option is enabled.
Fastboot Allows you to configure the speed of the UEFI boot process.
By default, the Minimal option is enabled.
Extend BIOS POST Time Set the BIOS POST load time.
By default, the 0 seconds option is enabled.
Table 41. System setup options—Virtualization menu
Virtualization
Intel Virtualization Technology
Enable Intel Virtualization Technology
(VT)
When enabled, the system will be able to run a Virtual Machine Monitor
(VMM).
By default, the option is enabled.
VT for Direct I/O When enabled, the system will be able to perform Virtualization Technology for
Direct I/O (VT-d).
By default, the option is enabled.
DMA protection
Enable Pre-Boot DMA Support Enables or disables Pre-Boot DMA Support
Default: ON
Enable OS Kernel DMA Support Enables or disables OS Kernel DMA Support
Default: ON
Table 42. System setup options—Performance menu
Performance
Multi-Core Support
All cores By default, All Cores are selected.
Active Core Selection By default, the number of cores is set at 01.
Multiple Atom Cores Enables to change the number of CPU cores available to the operating system.
By default, the All Cores option is selected.
Intel SpeedStep
Enable Intel SpeedStep Technology Enables the system to dynamically adjust processor voltage and core
frequency, decreasing average power consumption and heat production.
By default, the option is enabled.
C-States Control
Enable C-State Control Enable the ability of the CPU to enter and exit low power state. When disabled,
it disabled all C-states. When enabled, it enabled all C-states that the chipset
or platform allows.
BIOS Setup 107
To Next Page
Loading...
