Dell Inspiron 27 7720 All-in-One - Memory Module; Removing the Memory Module

3. Slide the solid-state drive into the M.2 card slot on the system board.
4. Replace the screw (M2x3.5) that secures the solid-state drive to the system board.
Next steps
1. Install the system-board shield.
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Memory module
Removing the memory module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
Figure 33. Removing the memory module
Steps
1. Carefully spread apart the securing-clips on each end of the memory-module slot until the memory module pops-up.
2. Slide and remove the memory module from the memory-module slot.
NOTE: Repeat steps 1 and 2 if you want to remove the other memory module.
Removing and installing Customer Replaceable Units (CRUs) 59