12. Follow the procedure in After working inside your computer.
Antennas
Removing the antennas
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the hard drive.
6. Remove the system-board shield.
7. Remove the media-card reader.
8. Remove the memory module.
9. Remove the wireless card.
10. Remove the M.2 2230 solid-state drive or, M.2 2280 solid-state drive, whichever applicable.
11. Remove the integrated heat sink or discrete heat sink
12. Remove the system board.
13. Remove the speakers.
14. Remove the stand hinges.
15. Remove the power-button board.
About this task
The following image indicates the location of the antennas and provides a visual representation of the removal procedure.
Figure 61. Removing the antennas
Removing and installing Field Replaceable Units (FRUs)
89
To Next Page
Loading...
