Figure 28. Changing 2280 to 2230
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Figure 29. Installing the M.2 2230 solid-state drive
Steps
1. Ensure that the thermal pad covering the M.2 2230 slot on the system board is in place.
2. Align the notch on the solid-state drive with the tab on the M.2 card slot.
3. Slide the solid-state drive into the M.2 card slot on the system board.
4. Replace the screw (M2x3.5) that secures the solid-state drive to the system board.
Next steps
1. Install the system-board shield.
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
56
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
