Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type
is restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Computer cover Chassis #6-32x6.35 2
2.5-inch hard drive(s)
NOTE: Depending
on the
configuration
ordered, there may
be up to two 2.5-
inch hard drives
installed.
Drive cage #6-32x6.35 1
2.5-inch hard drive(s)
NOTE: Depending
on the
configuration
ordered, there may
be up to two 2.5-
inch hard drives
installed.
Hard-drive bracket M3x3.5 4 (for each hard drive)
3.5-inch hard drive Drive cage #6-32x6.35 2
3.5-inch hard drive Hard-drive bracket #6-32x3.6 2
Drive cage Chassis #6-32x6.35 1
Optical drive Optical-drive bracket M2x2 3
Wireless card System board M2x3.5 1
Power-supply unit Chassis #6-32x6.35 3
3
Screw list 11
To Next Page
Loading...
