Replacing the optical drive
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Align and replace the optical-drive bezel to the optical drive.
2. Slide the optical drive into the optical-drive cage
3. Align the screw holes on the optical drive with the screw holes on the drive cage and replace the three screws (M2x2) that secure the
optical drive to the drive cage.
4. Place the drive cage on the chassis.
5. Connect the data cable and power cable to the optical drive.
6. Connect the data cables and power cables to the hard drives.
17
Replacing the optical drive 35
To Next Page
Loading...
