Replacing the power-button module
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Route the power-button board cable through the slot on the front panel.
2. Connect the power-button board cable to the system board.
3. Slide the front-I/O bracket into the slots on the chassis and align the screw holes on the front-I/O panel with the screw holes on the
chassis.
4. Replace the screw (#6-32x6.35) that secures the front-I/O bracket to the chassis.
29
Replacing the power-button module 51
To Next Page
Loading...
