Replacing the 2.5-inch hard drive
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Slide the bottom hard drive into the hard-drive bracket.
2. Align the screw holes on the bottom hard drive with the screw holes on the hard-drive bracket.
3. Replace the four screws (M3x3.5) that secure the bottom hard-drive to the hard-drive bracket.
4. Align the screw holes on the top hard drive with the screw holes on the hard-drive bracket.
5. Replace the four screws (M3x3.5) that secure the top hard drive to the hard-drive bracket.
6. Slide the hard drive into the slot on the drive cage until it snaps into place.
7. Replace the screw (#6-32x3.6) that secures the hard-drive assembly to the drive cage.
13
26 Replacing the 2.5-inch hard drive
To Next Page
Loading...
