System Configuration
• RAID On (default)
Drives Enable or disable various drives on board.
• SATA-0
• SATA-1
• SATA-2
• SATA-3
• M.2 PCIe SSD-0
By default, all the check boxes are selected.
SMART Reporting Enable or disable Self-Monitoring, Analysis, and Reporting Technology (SMART)
during system startup. This option is disabled by default.
USB Configuration Configures the integrated USB controller. If Boot Support is enabled, the computer is
allowed to boot any type of USB Mass Storage Devices (HDD, memory key, floppy).
If USB port is enabled, the device attached to this port is enabled and available for
OS.
If USB port is disabled, the OS cannot detect any device attached to this port.
• Enable USB Boot Support
• Enable Front USB Ports
• Enable Rear USB Ports
By default, all the check boxes are selected.
NOTE: USB keyboard and mouse always work in the BIOS setup
irrespective of these settings.
Front USB Configuration Enable or disable the front USB ports.
• Front Port 1
• Front Port 2
By default, all the check boxes are selected.
Rear USB Configuration Enable or disable the rear USB ports.
• Rear Port 1
• Rear Port 2
• Rear Port 3
• Rear Port 4
By default, all the check boxes are selected.
Audio Enable or disable the integrated audio controller.
By default, Enable Audio is selected.
Miscellaneous Devices Enable or disable the Secure Digital (SD) card reader.
By default, Enable Secure Digital (SD) Card is selected.
Table 5. System setup options—Video menu
Video
Primary Display This option determines which video controller becomes the primary display when
multiple controllers are available in the computer.
• Auto (default)
• Intel HD Graphics
70 System setup
To Next Page
Loading...
