Steps
1. Ensure that the securing clips are in an open position.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Insert the memory module into the memory-module connector until the memory module snaps into position and the securing
clip locks in place.
NOTE:
The securing clips return to the locked position. If you do not hear the click, remove the memory module and
reinstall it.
NOTE: Repeat step 1 to step 3 when installing more than one memory module in your computer.
4. Place the computer in an upright position.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the solid-state drive/Intel Optane
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
NOTE:
Depending on the configuration ordered your computer may come with one of the following modules installed:
● M.2 2230 solid-state drive
Removing and installing components 19
To Next Page
Loading...
