● M.2 2280 solid-state drive
The following image(s) indicate the location of the solid-state drive/Intel Optane and provides a visual representation of the
removal procedure.
Steps
1. Lay the computer with its left side facing up.
2. Remove the screw (M2x3.5) that secures the solid-state drive to the system board.
3. Slide and lift the solid-state drive from the M.2 card slot on the system board.
Installing the solid-state drive/Intel Optane
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
You may install the following supported modules on your computer's M.2 card slot:
20 Removing and installing components
To Next Page
Loading...
